Vicon SURVEYOR 2000 7003-00, Руководство по установке и эксплуатации

Страница: 38 / 64

Figure 28
Use of the Optional Alarm Kit
Using the Optional Alarm Kit
(S2000-ACL)
This optional Alarm Kit consists of a termination
box and RJ-45 Cable. It is used to assist in using
connector J2, an RJ-45 socket on the Power
Supply/Communication Board. Connector J2
provides access to the 4 alarm inputs. The RJ-45
cable has one male end, which plugs directly into
connector J2, and color-coded open wires on the
other, which connect to the termination box. Since
the RJ-45 cable is 10 feet (2.5 m), the termination
box must be mounted within the vicinity of the
Surveyor2000. Use of this kit is similar to the
accessory kit.
The termination box provides a convenient
connection from open wires to open wires. After
the cable is passed through the cable fitting
(ceiling-mounted Surveyor2000 only), connect it to
termination box’s terminals.
When the cover of the termination box is removed,
the pre-wired terminal block will resemble Figure
28. Feed the control cable into the side and
connect each wire to the appropriate screws. Use
Table 1 to reference the proper color-to-signal
code. Do the same with the cable from the
Surveyor2000. Figure 28 is shown wired for a
typical Surveyor2000 using ALARM 1 and ALARM
2.
WIRE COLOR SIGNAL NAME
(alarms)
WHITE/GREEN or WHITE ALARM 1
GREEN or BLACK VSSA
WHITE/ORANGE or GREEN ALARM 2
BLUE or ORANGE VSSA
WHITE/BLUE or YELLOW ALARM 3
ORANGE or RED VSSA
WHITE/BROWN or BLUE ALARM 4
BROWN VSSA
Table 1
Alarm Signal Wire Color Code
34
•
Wiring XX031-01 Rev 803 Surveyor2000 Camera Dome System