Vicon SURVEYOR 2000 7003-00, Руководство по установке и эксплуатации

Страница: 47 / 64

Uninstalling the Surveyor2000
The Surveyor2000 can be easily uninstalled by simply removing the camera dome from the housing or the
camera drive from the enclosure. The In-Ceiling Mount model requires removal of the camera rrive and the
Pendant models require removal of the camera dome assembly. A safety cord is always available to safely
hang the camera drive or camera dome assembly while installing or uninstalling.
CAUTION: Disable the AC power before attempting uninstallation of the Surveyor2000 to avoid injury to
the technician and damage to the unit.
For an In-Ceiling Installation
Figure 31
In-Ceiling Mount Model Uninstallation
1. Gently pull down on the lower dome’s
outside edge, with two hands, until all
molded tabs snap out of place.
2.
Loosen the 3 captive drive
mechanism screws from the camera
drive and lower it from the ceiling. It
will hang from the safety cord. Refer
to Figure 31.
3. If it is necessary to completely remove
the camera drive, disconnect the
safety cord clip and all cables.
For a Pendant Installation
1. (Outdoor Pendant model only)
Loosen the 4 trim ring screws from
the outdoor lower dome.
2. Gently pull down on the lower
dome’s outside edge, until it snaps
out of place.
3. Grasp
the housing
(sunshield/housing for the Outdoor
Pendant model) at the base with both
hands near the housing clips.
Squeeze the housing clips outward
until the Surveyor2000 is released.
Refer to Figure 32.
4. Allow the Surveyor2000 to gently
drop down until it is supported by the
safety cord.
5. If it is necessary to completely remove the Surveyor2000, remove all cable connectors from the
Communication Power Supply Board and from the cable clamp.
Figure 32
Pendant Version Uninstallation
6. Disconnect the clip on the end of the safety
cord from the latch on the top of the enclosure.
XX031-01 Rev 803 Surveyor2000 Camera Dome System Uninstalling the Surveyor2000
•
43