Vicon SURVEYOR 2000 7003-00, Руководство по установке и эксплуатации

Страница: 35 / 64

WARNING : If Vicoax mode is being used, DO NOT wire TB3 for control, as this will cause the camera
dome program to lock up upon power-up.
6. Reinstall the terminal blocks
TB1 and TB3 into the
Communication Power Supply
Board at the proper block
frames.
7. Install the video BNC cable
connector to the
Communication/Power Supply
Board’s mating BNC connector.
ALTERNATE CONNECTION:
For the models using the UTP
video connection, use the
twisted-pair video wires Attach
each wire to screw terminal
TB4 on the top of the
enclosure. This signal is non-
polarized and specific wire
connection is not necessary.
Refer to the instructions supplied with the receiver for those connections.
Figure 22
Indoor Pendant Mount Cable Installation
8. Plug in all RJ-45 cable connectors to their corresponding mating connectors J1 and J3.
WARNING : Failure to insert the RJ-45 connectors into the correct mating connectors can cause damage
to the Communication Power Supply Board upon power-up.
9. Place each cable into the
enclosure’s cable retainer (for
the Outdoor version, under the
fan bracket as shown in Figure
23.) The safety cord should
now provide sole support of the
Surveyor2000 and the cables
should be slack and
comfortably run to their
connectors. Push any
remaining cable back through
the top of the housing until the
cabling comfortably passes
directly from the cable clamp
(fan’s bracket) to the top of the
housing.
Figure 23
Outdoor Pendant Mount Cable Installation
XX031-01 Rev 803 Surveyor2000 Camera Dome System Wiring
•
31