Vicon SURVEYOR 2000 7003-00, Руководство по установке и эксплуатации

Страница: 33 / 64

Installing the Cables
WARNING: Disable the AC power to prevent installer injury and damage to the unit.
Cables are installed using 2 different methods, depending on the installation type. For the In-Ceiling
installation, cables are routed from above the ceiling through a conduit fitting on the enclosure to the board.
For the Pendant installation, cables are routed from the inside of the housing through a cable clamp to the
Communication Power Supply Board.
For an In-Ceiling Installation
1. Remove the enclosure’s top cover by loosening the 3 screws and lifting it off.
2. Place all cables through the conduit fitting on the side of the enclosure. Verify that all cables have been
routed through 0.5 inch (13 mm) rigid or flexible conduit pipe.
NOTE : Connectors that do not fit through the conduit fitting must be cut off and re-terminated after passing
the cable through. It is recommended to pass any RJ-45 connectors through the fitting first. BNC type
connectors do not fit through the fitting and must be terminated later.
NOTE : If conduit pipe is not used, the supplied strain relief fitting must be installed in place of the one
installed to provide sufficient cable strain relief.
Figure 21
In-Ceiling Mount Model Cable Installation
Maneuver all cables as shown in Figure
21. Looping all cables around the inside
provides natural strain relief and prevents
sharp bends 3.
which could lead to broken
cables later.
NOTE: Failure to loop the cables can prevent
later removal of the camera drive
from the ceiling.
Cut all cables to their approximate
required lengths. Leave approxima 4.
tely 1
inch (25 mm) extra for termination.
5.
he control
signals will be terminated here.
6.
s (6 mm) of
insulation off of each wire.
7. NC type male connector. Terminate the 8-conductor alarm
cable with an RJ-45 male connector, if used.
Remove terminal blocks TB1 and/or TB3.
The control signals exist in both TB3 and
J3 and the Relay signals exist only in J3.
Therefore, remove TB3 only if t
Strip approximately 2 in. (51 mm) of
insulation off of twisted-pair wire sets or
cables used for power, control, UTP video
(optional) alarms and relays. Then strip
approximately 0.25 inche
Terminate the video (coaxial) cable with a B
XX031-01 Rev 803 Surveyor2000 Camera Dome System Wiring
•
29