Step 1 – PREPARING TO MOUNT THE CAMERA
Step 3 – INSTALLING THE CAMERA
Step 2 – CABLING THE CAMERA TO EXTERNAL DEVICES
1.
The mounting surface must bear five times the weight of your camera.
2.
Do not let the cables get caught in improper places or the electric line cover to
be damaged. This may cause a breakdown or fire.
3.
For the installation process, remove the junction box and dome cover from the
camera module. To remove the camera dome, loosen the three (3) screws on
the dome using the wrench provided with the camera. To remove the junction
box, loosen the three (3) screws on the camera module using the driver
provided with the camera.
4.
Using the mounting template sheet or the camera’s junction box, mark and drill
the necessary holes in the wall or ceiling.
5.
Secure the junction box to the mounting surface.
7.
Secure the camera module to the junction box using three (3) screws.
8.
Use the camera’s 3-Axis gimbal to adjust the camera’s tilt and angle. The
camera’s maximum tilting angle is 75° (90° for non-IR models).
9.
Assemble the dome cover over the camera body and detach the protecting film
from the dome bubble.
6.
Pass the wires through the mount bracket and make all necessary connections.
a.
NETWORK CONNECTIONS – If you are using a PoE Switch, connect the
camera using an Ethernet cable for both data and power.
b.
NETWORK CONNECTIONS – If you are using a non-PoE switch, connect
the camera to the switch using an Ethernet cable for data transmission and
use a power adapter to power the camera.
Power Requirements
Power Consumption
DC 12V
PoE IEEE 802. / PoE Class 3
LED Off: 7.2W, 600mA
LED On: 8.64W, 720mA (IR models)
NETWORK
CONNECTION
POWER
1
2
3
5
4
Template
Sheet
Factory
Reset
Switch
Quick Start Guide
Quick Start Guide
Username:
admin
Password:
admin
Attention: This document is intended to serve as a quick reference page for initial set-up.
It is recommended that the user read the entire instruction manual for complete and proper
camera usage.
Tel: 866-446-3595 / 813-888-9555
Technical Support Hours:
9:00AM – 8:00PM EST, Monday thru Friday
digital-watchdog.com
WHAT’S IN THE BOX
QSG Manual
1 Set
Star Driver
1 Set
Manual CD
1 Set
Screw & Plastic
Anchor – 4pcs
1 Set
Template Sheet
1 Set
DC Plug Cable
1 Set
Hexagonal
Wrench
1 Set
Test Video
Cable
1 Set
Resetting the camera:
To reset the camera, use the tip of a paper clip or
a pencil and press the reset button. Pressing the button for five (5) seconds
will initiate a camera-wide reset of all the settings, including network settings.
DWC-MV421D
DWC-MV421DB
DWC-MV421TIR
DWC-MV421TIRB
DWC-MV421TIRB
DWC-MV421TIR
DWC-MV421DB
DWC-MV421D
