Vertiv NetSure 710 Series, Руководство по установке

Страница: 47 / 142

Vertiv
| NetSure 710 Series Installation Manual (IM581127000) | Rev. U 47
Switch Settings on IB2 Interface Board
Dip Switch SW1 on the IB2 board is used to set the communications address for this board. Refer to Table 1 for
SW1 settings. Refer to Figure 21 for SW1 location.
Perform the following procedure to verify the factory settings. This procedure can also be used to make
adjustments on a replacement circuit card.
Procedure
1. Ensure SW1 is set per Table 1 . Refer to Figure 21 for location.
Table 1:
IB2 Interface Board Switch Settings
Setting
DIP Switch SW1
1 2
IB2 OFF OFF
Switch Setting on Optional EIB Interface Board
Dip Switch SW1 on the EIB board is used to set the communications address for this board. Refer to Table 2 for
SW1 settings. Refer to Figure 22 for SW1 location.
Perform the following procedure to verify the factory settings. This procedure can also be used to make
adjustments on a replacement circuit card.
Procedure
1. Ensure SW1 is set per Table 2 . Refer to Figure 22 for location.
Table 2:
Optional EIB Interface Board Switch Settings
Setting
DIP Switch SW1
1 2
EIB ON OFF