Vertiv NetSure 710 Series, Руководство по установке

Страница: 88 / 142

Vertiv
| NetSure 710 Series Installation Manual (IM581127000) | Rev. U 88
NCU Controller Second Ethernet Port Connection (if IB4 board furnished)
Your system may be furnished with an IB4 board connected to the NCU backplane via a factory furnished and
connected cable. The IB4 board provides a second Ethernet port. The Ethernet port located on the NCU
Controller’s front panel can ONLY be used to connect a computer directly to the NCU. The Ethernet port
located on the IB4 board can be used to connect the NCU to your Local Area Network (LAN).
NOTE!
If your system has an IB4 board, DO NOT connect your Local Area Network (LAN) to the NCU
front Ethernet port.
An RJ-45 10BaseT jack is provided on the IB4 board for connection into a customer's network. This jack has a
standard Ethernet pin configuration scheme, twisted pair. Refer to
Figure 35
for location and
Table 11
for pin
outs. Use shielded Ethernet cable (grounded at both ends). Note that the IB4 board’s RJ-45 jack is connected
to chassis ground. Refer to the NCU Instructions (UM1M830BNA) for operational details.
WARNING! The intra-building port(s) of the equipment or subassembly is suitable for connection to
intra-building or unexposed wiring or cabling only. The intra-building port(s) of the equipment or
subassembly MUST NOT be metallically connected to the interfaces that connect to the OSP or its
wiring. These interfaces are designed for use as intra-building interfaces only (Type 2 or Type 4 ports as
described in GR-1089-CORE, Issue 4) and require isolation from the exposed OSP cabling. The addition
of Primary Protectors is not sufficient protection in order to connect these interfaces metallically to OSP
wiring.
The intra-building port (RJ-45) of the equipment or subassembly must use shielded intra-building
cabling/wiring that is grounded at both ends.