FCC ID: K66VX-7R
Operating Manual
Vertex Standard Co., Ltd.
41
you wish to recall.
5.
To exit the One-Touch Memory mode, recall the Special Memory Menu (press
[MON/F] + [9(SPCL)]), then select its setting to “OFF.”
Scanning
Scanning
Scanning
Scanning
The VX-7R allows you to scan just the memory channels, the entire operating band,
or a portion of that band. It will halt on signals encountered, so you can talk to the
station(s) on that frequency, if you like.
Scanning operation is basically the same in each of the above modes. Before you
begin, take a moment to select the way in which you would like the scanner to resume
scanning after it halts on a signal.
Setting the Scan Resume Technique
Setting the Scan Resume Technique
Setting the Scan Resume Technique
Setting the Scan Resume Technique
Three options for the Scan-Resume mode are available:
5 SEC: In this mode, the scanner will halt on a signal it encounters, and will hold
there for 5 seconds. If you do not take action to disable the scanner within
that time period, the scanner will resume even if the stations are still
active.
BUSY: In this mode, the scanner will halt on a signal it encounters. Two seconds
after the carrier has dropped because the other station(s) ceased
transmission, the scanner will resume. In the case of constant-carrier
signals like Weather Station broadcasts, the scanner will likely remain on
this frequency indefinitely.
HOLD: In this mode, the scanner will halt on a signal it encounters. It will not
restart automatically; you must manually re-initiate scanning if you wish
to resume.
To set the Scan-Resume mode
1.
Press the [MON/F] key, then press the [0(SET)] key to enter the Set mode.
2.
Rotate the DIAL to select Menu Item (Scan Modes #3: RESUME).
3.
Press the [MAIN] or [SUB] key to select the desired scan-resume mode.
4.
When you have made your selection, press the PTT key to save the new setting and
exit to normal operation.
R
R
R
R....F
F
F
F.... Say
Say
Say
Say
: The default condition for this Menu Item is “5 SEC.”