Vertex Standard VX-7R, Руководство по эксплуатации

Страница: 13 / 74

FCC ID: K66VX-7R
Operating Manual
Vertex Standard Co., Ltd.
13
is below 100 MHz (e.g. 15.150 MHz), any required leading zeroes must be entered.
However, there is a short-cut for frequencies ending in zero - press the [V/M(WRITE
MT)] key sfter the last non-zero digit.
Examples:
To enter 146.520 MHz, press [1]
"
[4]
"
[6]
"
[5]
"
[2]
"
[0]
To enter 15.255 MHz, press [0]
"
[1]
"
[5]
"
[2]
"
[5]
"
[5]
To enter 1.250 MHz (1250 kHz), press [0]
"
[0]
"
[1]
"
[2]
"
[5]
"
[0]
To enter 0.950 MHz (950 kHz), press [0]
"
[0]
"
[0]
"
[9]
"
[5]
"
[0]
To enter 430.000MHz, press [4]
"
[3]
"
[V/M(WRITE MT)]
3) Scanning
From the VFO mode, press the [MON/F] key, then press the [1(SCAN)] key. The VX- VX- VX- VX-
7R 7R 7R 7R will begin scanning toward a higher frequency, and will stop when it receives a
signal strong enough to break through the Squelch threshold. The VX-7R will then hold
on that frequency according to the setting of the “RESUME” mode (Menu Item: Scan
Modes #3). See page ?? for details.
If you wish to reverse the direction of the scan (i.e. toward a lower frequency, instead
of a higher frequency), just rotate the DIAL one click in the counter-clockwise direction
while the VX-7R is scanning. The scanning direction will be reversed. To revert to
scanning toward a higher frequency once more, rotate the DIAL one click clockwise.
Press the PTT switch momentarily to cancel the scanning.
Dual Receive Operation Dual Receive Operation Dual Receive Operation Dual Receive Operation
The VX-7R may be operate dual frequency receive.
Press and hold the [MAIN] or [SUB] key for 2 second to activate the Dual Receive
operation.
While Dual Receive operation, “Main” band frequency display upper side and “Sub”
band frequency display lower side, and “Operating” band (enabling the transmit and
band/frequency change) indicate
large characters.
To switch the “Operating” band, press the [MAIN] key momentarily to switch the
“Main” band frequency to the “Operating” band. Meanwhile, press the [SUB] key
momentarily to switch the “Sub” band frequency to the “Operating” band, described
previously.
R.F. Say R.F. Say R.F. Say R.F. Say : The “Sub” band frequency is possible operate only on the amateur bands, but
you can select both bands to receive different frequencies on the same bands.