Manaras Opera 100 Series, Технические характеристики и инструкции по программированию

Страница: 1 / 4

Rolling Code Transmitters - Series "100"
Rolling Code Transmitters - Series "100"
Specifications and Programming Instructions
Specifications and Programming Instructions
➢
Transmitter Programming: RADIOEM101, RADIOEM102, RADIOEM103, RADIOEM104
The Opera Brand Transmitters can be used as either a 1-Door x 3-Button Transmitter or as a Multiple-Door Transmitter
(Commercial Sequence or SBC). Commercial Sequence or SBC settings depend on the operator programming settings.
The Transmitters can be re-programmed as needs change. Replacement Battery: 1x CR2032 (3V).
Transmitter Modes and Functions Transmitter Programming
RADIOEM101
1-Door
1-Button Transmitter (1)
1.OPEN / STOP / CLOSE → Only Button
No initial programming is required.
The Transmitters are ready to be matched to the
Receiver of your choice, refer to section Transmitter
to Operator Matching (Pairing), p. 3.
RADIOEM104
4-Door
4 x 1-Button Transmitter (1)
1.DOOR #1 → Top Left Button
2.DOOR #2 → Top Right Button
3.DOOR #3 → Bottom Left Button
4.DOOR #4 → Bottom Right Button
(1) Each button acts separately as a 1-Button Transmitter.
Commercial Sequence or SBC Programming depends on the Operator Settings , please refer
to the Commercial Sequence or SBC Programming instructions, p. 4).
RADIOEM102
Mini Key Chain
1-Door
3-Button Transmitter
(Factory default for RADIOEM103SD)
1.OPEN → Top Button
2.CLOSE → Middle Button
3.STOP → Bottom Button
1.Press and HOLD Buttons
j
and
l
for 5 sec .
The RED LED will BLINK .
You have 15 sec. to complete the configuration or
you will need to restart.
2.Release Buttons
j
and
l
.
3.Press Button
j
.
4.The RED LED will stop blinking.
Programming is now complete.
RADIOEM103
Single Door (SD) /
Multiple Door
(MD)
3-Door
3 x 1-Button Transmitter
(1)
(Factory default for RADIOEM102 &
RADIOEM103MD)
1.DOOR #1 → Top Button
2.DOOR #2 → Middle Button
3.DOOR #3 → Bottom Button
1.Press and HOLD Buttons
j
and
l
for 5 sec .
The RED LED will BLINK .
You have 15 sec. to complete the configuration or
you will need to restart.
2.Release Buttons
j
and
l
.
3.Press Button
l
.
4.The RED LED will stop blinking.
Programming is now complete.
(1) Each button acts separately as a 1-Button Transmitter.
Commercial Sequence or SBC Programming depends on the Operator Settings , please refer
to the Commercial Sequence or SBC Programming instructions, p. 4).
1-800-361-2260
www.manaras.com
1
TN1054 REV 2 - 2022/01/24
j
k
l
m
k
l
j
j
j
k
l