FCC ID: K66VX-7R
Operating Manual
Vertex Standard Co., Ltd.
39
previous data, if you’re not careful. Use the “next available memory” technique (look for
the [*] icon) storage technique to avoid over-writing a masked memory.
Memory Group Operation
Memory Group Assignment
1.
Recall the memory channel to be assigned to a Memory Group.
2.
Press and hold the [MON/F] key for 2 seconds, then press the numbered key ([0] ~
[9]) you want as the Memory Group for this channel.
3.
Now memory channel data is copied into the Memory Group.
Memory Group Recall
1.
Set the radio to the Memory mode by pressing the [V/M(WRITE MT)] key, if
necessary.
2.
Press the [MON/F] key, then press the [9(SPCL)] key to recall the Special Memory
Menu.
3.
Press the [MAIN] or [SUB] key to select the “Memory Group” mode.
4.
Press the PTT switch to activate the “Memory Group” mode.
5.
Rotate the DIAL knob to select the desired Memory Group (“MG0” ~ “MG9”).
6.
Press the [V/M(WRITE MT)] key momentarily to lock in the selected Memory
Group.
7.
In the Memory Group, you selects the memory channel in the current memory
group only (up to 64 channels).
8.
To change the Memory Group to the other Group, press the [V/M(WRITE MT)] key
momentarily then rotate the DIAL knob.
9.
To exit the Memory Group, recall the Special Memory Menu (press [MON/F] +
[9(SPCL)]) then select its setting to “OFF.”
Hyper Memory Mode
Hyper Memory Mode
Hyper Memory Mode
Hyper Memory Mode
This feature enable to store the current status of the radio into the special memory bank
(Hyper Memory).
For example, if you store the Spectrum Operation
Hyper Memory Storage
1.
Setup the transceiver desired status, such as the Spectrum Operation, PMS
scanning, etc.
2.
Press and hold the numeric key ([0] through [9]) corresponding to the Hyper