i2 MX USER’S MANUAL: SECTION 7
VIRGINIA PANEL CORPORATION
2/5/16
7-1
For the most current information available, visit www.vpc.com
i2 MX MODULE INSERT(S) INSTALLATION/REMOVAL
PART # 310 130 XXX AND 410 130 XXX
TOOLS REQUIRED
Phillips Head Screwdriver
i2 MX MODULE INSERT(S) REMOVAL INSTRUCTIONS
1. If working with a receiver, use a Phillips head screwdriver to remove
strain relief by removing screws (
Figure A
).
The ITA will require removal of backshell first see
Section 4
of this User’s
Manual.
2. Using a Phillips head screwdriver, remove the two Phillips flat head
screws that are holding the frame halves together.
For ITA use a Phillips head screwdriver to loosen the two captive screws
on the back of rear frame (
Figure B
).
3. Pull halves apart.
4. Remove module insert(s).
i2 MX MODULE INSERT(S) INSTALLATION INSTRUCTIONS
1. For installing module insert(s), orient insert(s) as shown in (
Figure A
)
and
(
Figure C
). Place insert(s) ledge on flat surface shown in (
Figure D
), then
put halves together and tighten with flat head screws using a Phillips
head screwdriver.
NOTE: Receiver/ITA frame halves are keyed to be placed together only one
direction.
Figure A. Module insert install and removal
(receiver shown).
Figure D. Module insert install and removal
(receiver shown).
Figure C. Module insert install and removal
(receiver shown).
RECEIVER PIN
A1 UPPER LEFT
ITA PIN A1
UPPER RIGHT
PHILLIPS
FLAT HEAD
SCREWS (2)
FLAT SURFACE
Figure B. ITA frame separation.
PHILLIPS
CAPTIVE
SCREWS (2)
