Twister T-ZERO, Руководство по техническому обслуживанию и уходу

Страница: 64 / 81

63
ADJUSTING THE PULSE JET SETTINGS
The Pulse Jet has two different running modes: Continuous Cleaning and Clean at High
Pressure . Continuous Cleaning triggers the pulse jet at a set time interval. Clean at
High Pressure pulses when the filters have a specified pressure drop across them.
WHEN TRIMMING DRY IT IS RECOMMENDED TO USE THE CONTINUOUS
CLEANING OPTION.
To adjust the Pulse Jet settings from the front panel:
1. Hold down the SET button on the cover of the Filter Stack Controller for
two seconds to get into program mode.
2. Use the up and down arrows to adjust the setpoints.
3. Press the
SET button repeatedly to toggle through each parameter. The
order of parameters is as follows:
a) High Alarm Setpoint: triggers an alarm when the filters need to be
replaced (6” W.C. is the default setting).
b) Cleaning Low Setpoint: the pressure at which the pulse jet stops
operating.
c) Cleaning High Setpoint: the pressure where the pulse jet will turn
on and then operate until the “Cleaning Low Setpoint” is reached.
d) Unit of Measure: changes pressure units between “Inches of Water
Column” to kPA.
e) Security Code: allows the settings to be password protected.
Setting these numbers to anything other than “0.0.0” will prompt