Trane VarioTrane TR1 2800 Series, Руководство по эксплуатации

Страница: 18 / 137

Programming
001 Language
Value:
English (english) [0]
German (deutsch) [1]
French (francais) [2]
Danish (dansk) [3]
Spanish (espanol) [4]
Italian (italiano) [5]
Function:
This parameter is used to choose the language to be
shown in the display whenever the LCP control unit
is connected.
Description of choice:
There is a choice of the languages shown. The factory
setting may vary.
002
Value:
Remote operation (REMOTE) [0]
Local operation (LOCAL) [1]
Function:
There is a choice of two different modes of operation
of the adjustable frequency drive;
Remote operation
[0] or Local operation [1]. See also parameter 013 Local
control
if
Local operation
[1] is selected.
Description of choice:
If
Remote operation
[0] is selected, the adjustable fre-
quency drive is controlled via:
1. the control terminals or via serial communica-
tion.
2. the [START] key. This cannot, however, override
stop commands transmitted via the digital inputs
or via serial communication.
3. the [STOP/RESET] and [JOG] keys, on the condi-
tion that these are active.
If Local operation [1], is selected, the adjustable fre-
quency drive is controlled via:
1. the [START] key. This cannot, however, override
stop commands via the digital inputs (see pa-
rameter 013
Local control ).
2. the [STOP/RESET] and [JOG] keys, on the condi-
tion that these are active.
3. the [FWD/REV] key, on the condition that is has
been selected as active in parameter 016
Local
reversing , and that parameter 013 Local control is
set at Local control and open loop [1] or Local control
as parameter 100 [3]. Parameter 200 Output fre-
quency range is set at Both directions .
4.
parameter 003 Local reference where the refer-
ence can be set using the [+] and [-] keys.
5. an external control command that can be con-
nected to the digital inputs (see parameter 013
Local control ).
NOTE:
The [JOG] and [FWD/REV] keys are located on the LCP
control unit.
003 Local reference
Value:
Par. 013 Local control must be set to [1]
or [2]:
0 - f MAX (par. 205)
50 Hz
Par. 013 Local control must be set to [3] or
[4].
Ref MIN - Ref MAX (par. 204-205)
0,0
Function:
In this parameter, the local reference can be set man-
ually. The unit of the local reference depends on the
configuration selected in parameter 100
Configura-
tion .
Description of choice:
In order to protect the local reference, parameter 002
Local/remote operation
must be set to
Local operation
[1]. Local reference cannot be set via serial commu-
nication.
TR1 2800 Series VFD 17
Operation Display