Toro Greensmaster eFlex 1800, Руководство по обслуживанию

Страница: 94 / 312

Assembling the Transmission Drive System (continued)
D. Install the set screw (item 8 in Figure 53 ) into the end of the pulley and
tighten against the drive spline.
E. Secure the splined coupler in the driven pulley with the retaining ring
(item 4 in Figure 53 ).
2. Install all the components that were removed onto the driven pulley (item
12 in Figure 53 ).
A. If the ball bearings (items 15 and 5 in Figure 53 ) were removed from the
driven pulley, press the new bearings onto the pulley.
B. As necessary, install the flocked bearing shield (item 6 in Figure 53 )
(flocked side orientated toward bearing location), wave spring, and flat
washer onto the driven pulley. Secure the components with the retaining
ring.
3. If the motor adapter (item 2 in Figure 53 ) was removed from the transmission
housing, secure the adapter to the housing with the 4 washer-head screws.
Tighten the screws as follows:
A. First, use an alternating crossing pattern, torque all the screws to 1.7 to
4.5 N∙m (15 to 40 in-lb) .
B. Again use an alternating crossing pattern, torque all the screws to 9.6 to
10.7 N∙m (85 to 95 in-lb) .
4. Slide the driven pulley assembly (including bearings) into the motor adapter.
5. Install the transmission drive belt and all the machine components removed
for the reel drive system service; refer to Transmission Drive Belt (page
4–38) .
6. Fill the internal spline area of the splined coupler with high temperature Mobil
XHP-222 grease (or equivalent).
7. Install the electric motor to the transmission; refer to Electric Motor (page
5–69) .
8. Connect the battery pack; refer to Connecting the Lithium Battery Pack
(page 4–3) .
Traction and Reel Drive System: Service and Repairs Page 4–52 Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E