Toro Greensmaster eFlex 1800, Руководство по обслуживанию

Страница: 147 / 312

Key Switch
g202435
Figure 98
1. Key switch 4. Lower handle
2. Washer-head screw (4 each) 5. Switch panel
3. Console cover
The key switch allows the machine operation to be turned on and off. The key
switch has 3 positions: O
FF
, R
UN
, and S
TART
. This switch is 1 of the several
inputs for the TEC and is located on the switch panel ( Figure 98 ).
Check the key switch operation with the InfoCenter on the console. With the key
switch in the R
UN
position, the InfoCenter should allow the information screen
to be displayed. With the InfoCenter in the diagnostics menu, choose the Key
Start and ensure that the switch state changes as the key switch is moved to
the S
TART
position and is then released. If the InfoCenter operation suggests a
damaged key switch, proceed to the key switch testing below.
Note: If the eFlex machine is sitting idle for 5 minutes with the key switch in the
R
UN
position, the machine will shut off.
Note: A damaged key switch may cause a #12 fault to be generated and
displayed on the InfoCenter. Refer to the Faults Screen (page 5–26) for
information on faults.
Testing the Key Switch
1. Park the machine on a level surface and place the traction lever in the
N
EUTRAL
position. Turn the key switch to the O
FF
position and remove the
key from the key switch.
2. Disconnect the battery pack; refer to Connecting the Lithium Battery Pack
(page 5–7) .
3. Remove the console cover from the handle to get access to the key switch
( Figure 98 ).
4. Disconnect the wire harness electrical connector from the key switch.
Greensmaster ® eFlex 1800, 2100 and 2120 Page 5–47 Electrical System: Testing the Electrical Components
12189SL Rev E