Toro Greensmaster eFlex 1800, Руководство по обслуживанию

Страница: 242 / 312

Removing the Cutting Unit Assembly (continued)
g206896
Figure 178
1. Cutting unit 4. Bearing lock screw (right-hand threads)
2. Flocked seal (2 each) 5. Reel driveshaft (left-hand threads)
3. Bearing (2 each) 6. Reel groove location
5. If the bearings or seals are to be removed from the cutting unit, put a block
of wood between the cutting unit blades to prevent the reel from rotating.
Loosen the bearing lock screw (right-hand threads) and the reel driveshaft
(left-hand threads) to allow easier removal after reel assembly is removed
from the cutting unit (
Figure 178 ).
6. Remove the bedbar pivot bolt and washers from the right side plate. For
assembly purposes, note the location of plastic and steel washers; refer to
Removing the Bedbar (page 7–10) .
7. Loosen the fasteners that secure the front and rear rollers to the right side
plate; refer to Removing the Front Roller (page 7–18) and Removing the
Rear Roller (page 7–20) .
8. Support the cutting unit to prevent it from shifting or falling.
9. Remove the shoulder bolts (item 8 in Figure 176 ) and flange nuts that secure
the right side plate to the cutting unit crossmember. Remove the right side
plate from the reel shaft, rollers, bedbar, and cutting unit crossmember.
Remove the right pitch arm and compression spring from the right side plate.
10. Carefully slide the cutting unit assembly with the flocked seals (item 2 in
Figure 178 ), reel bearings, bearing lock screw, and reel driveshaft from the
left slide plate. Locate and remove the flat wire spring (item 15 in Figure 176 ).
Cutting Unit: Service and Repairs Page 7–28 Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E