Toro Greensmaster eFlex 1800, Руководство по обслуживанию

Страница: 202 / 312

Removing the Reel Clutch Cable (continued)
g198903
Figure 139
1. Shift handle 3. Bottom cable jam nut 5. Reel clutch cable
2. Reel cable spring 4. Top cable jam nut
6. Shift mount bracket
4. Remove the reel clutch cable from the traction lever assembly ( Figure 139 )
as follows:
A. Loosen the bottom cable jam nut that secures the reel clutch cable to the
shift mount bracket on the handle. Slide the cable from the bracket.
B. Remove the cable spring from the spring anchor on the traction lever
assembly. Note the orientation of the cable spring hook on the traction
lever assembly for assembly purposes.
5. Remove the reel clutch cable from the machine.
Installing the Reel Clutch Cable
1. Secure the reel clutch cable to the traction lever assembly ( Figure 139 ) as
follows:
A. Install the cable spring to the spring anchor on the traction lever assembly.
Orientate the cable spring hook end toward front of the machine.
B. Slide the cable housing into the shift mount bracket slot. Ensure that a jam
nut, flat washer, and lock washer are on both sides of the bracket. Adjust
the jam nuts so that equal amount of cable threads are visible above and
below the jam nuts. Leave the jam nuts snug until final cable adjustment.
2. Route the reel clutch cable to the transmission and install the cable ( Figure
138 ) as follows:
A. Secure the cable eyelet to the transmission reel clutch lever with the
retaining ring.
B. Position the reel clutch cable to the casting slot of the transmission with a
jam nut, flat washer, and lock washer on each side of the slot.
C. Adjust and tighten the jam nuts to compress the cable spring to a length
from 70.6 to 72.4 mm (2.780 to 2.850 inches) .
D. Remove the rubber plug at front of the transmission to view reel clutch.
Ensure that the reel clutch teeth disengage when the clutch is released.
Chassis and Controls: Service and Repairs Page 6–12 Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E