Toro Greensmaster eFlex 1800, Руководство по обслуживанию

Страница: 233 / 312

Removing the Front Roller (continued)
3. Remove the cutting unit from the machine and place on a level working
surface. Use appropriate support to raise the front roller from the work
surface.
4. Loosen the bolt (item 6 in Figure 167 ) that secures the front roller shaft to the
each front height-of-cut arm.
5. On one of the height-of-cut arms, remove the HOC nut (item 5 in Figure 167 ),
HOC washer, and plow bolt that secure the HOC arm to the cutting unit side
plate. Remove the HOC arm from the cutting unit.
6. Slide the front roller assembly from the remaining HOC arm on the cutting
unit.
7. If necessary, remove the second HOC arm from the cutting unit.
Installing the Front Roller
1. Place the cutting unit on a level working surface and use appropriate support
to support the front of the cutting unit.
2. Inspect the condition of the HOC screws (item 3 in Figure 167 ) in both HOC
arms. If the screw replacement is necessary, apply anti-seize lubricant to the
threads of new HOC screw. Thread the new HOC screw into the HOC arm.
Note: When assembling HOC arms to the side plates, ensure that the ring
on HOC screw fits into the notch on the side plate.
3. If both the HOC arms were removed from the cutting unit side plate, position
one of the arms to the side plate. Secure the arm to the side plate with the
plow bolt (item 2 in
Figure 167 ), HOC washer, and HOC nut. The tab on the
HOC washer should be positioned into the HOC arm slot and orientated
down toward the roller.
4. Slide the front roller shaft into the arm attached to the cutting unit. Slide the
second HOC arm onto the other end of the roller shaft. Secure the second
arm to the cutting unit side plate with the plow bolt (item 2 in
Figure 167 ),
HOC washer, and HOC nut.
5. Center the front roller to the cutting unit and secure to the HOC arms with
the bolts.
6. Adjust the cutting unit; refer to the Cutting Unit Operator's Manual .
7. Install the cutting unit to the machine.
8. After all necessary adjustments have been made, connect the battery pack;
refer to Connecting the Lithium Battery Pack (page 7–3) .
Greensmaster ® eFlex 1800, 2100 and 2120 Page 7–19 Cutting Unit: Service and Repairs
12189SL Rev E