Toro Greensmaster eFlex 1800, Руководство по обслуживанию

Страница: 221 / 312

Leveling the Rear Roller
g206879
Figure 155
1. Shoulder bolt (4 each) 2. Side plate (right)
The precision machined components of the cutting unit frame keep the rear
roller and cutting unit in alignment (parallel). If the side plates are disassembled,
ensure that the rear roller is properly aligned to the reel. The reel should not
have any cone to this procedure.
1. Place the assembled cutting unit on a surface plate.
2. Ensure that the bedknife is properly adjusted to the cutting unit.
3. Use the surface plate, check if the rear roller is level to the cutting unit by
using a 0.13 mm (0.005 inch) shim at each end of the rear roller. If the shim
will pass under the roller at one end but not the other, a frame adjustment
should be made.
4. Loosen, but do not remove the 2 shoulder bolts that secure the side plate to
the frame opposite the side that is not level ( Figure 155 ).
5. Adjust the position of the side plate to parallel the rear roller and cutting unit.
Torque the shoulder bolts to 24 to 27 N∙m (210 to 240 in-lb) .
6. After tightening the side plate, check the rear roller. If necessary, loosen and
adjust the second side plate.
7. After leveling the rear roller, complete the cutting unit set-up and adjustment
sequence.
Greensmaster ® eFlex 1800, 2100 and 2120 Page 7–7 Cutting Unit: Adjustments
12189SL Rev E