Toro Greensmaster eFlex 1800, Руководство по обслуживанию

Страница: 231 / 312

Note: The detent used on eFlex 2100/2120 is toward the center of the cutting
unit as shown in Figure 165 . On eFlex 1800 cutting units, the detent is mounted
on the outside of the cutting unit crossmember ( Figure 166 ). Cutting unit service
procedures are the same on all models.
Removing the Bedbar Adjuster
1. Remove the locknut (item 4 in Figure 165 ), compression spring, and washer
from the bedbar adjuster screw.
2. Remove the bedbar; refer to Removing the Bedbar Adjuster (page 7–17) .
Note: The bedbar adjuster shaft (item 11 in Figure 165 ) has left-hand threads.
3. Unscrew the bedbar adjuster shaft from the bedbar adjuster screw.
4. Remove the retaining ring (item 8 in Figure 165 ) and wave washer from the
adjuster shaft and remove the adjuster shaft from the cutting unit frame.
5. Inspect the flange bushings (item 10 in Figure 165 ) in the cutting unit side
plate and remove if necessary.
6. If the detent is damaged, remove it from the cutting unit side plate by
removing the bolt.
Installing the Bedbar Adjuster
1. If the detent (item 1 in Figure 165 ) was removed, secure the detent to the
cutting unit side plate with the bolt.
2. If the flange bushings (item 10 in Figure 165 ) were removed, align the key
on the bushing to the slot in the frame and install the bushings in the cutting
unit side plates.
3. Slide the bedbar adjuster shaft (item 11 in Figure 165 ) into the flange
bushings in the cutting unit side plate. Secure the adjuster shaft with the
wave washer and retaining ring.
Note: The bedbar adjuster shaft has left-hand threads.
4. Apply anti-seize lubricant to the threads of the bedbar adjuster screw (item 7
in Figure 165 ) that fits into the adjuster shaft. Thread the bedbar adjuster
screw into the adjuster shaft.
5. Install the bedbar; refer to Installing the Bedbar (page 7–11) .
6. Install the washer (item 6 in Figure 165 ), compression spring, and locknut
onto the adjuster screw. Tighten the locknut on the each bedbar adjuster
assembly until the compression spring is fully compressed, then loosen the
locknut 1/2 turn.
7. Adjust the cutting unit; refer to the Cutting Unit Operator's Manual .
Greensmaster ® eFlex 1800, 2100 and 2120 Page 7–17 Cutting Unit: Service and Repairs
12189SL Rev E