7-15
7 DATA COLLECTION
5
Measure the second and third points in the same
way. *1)
Collimate
P2
{F1}
Collimate
P3
{F1}
The display changes to PT# input in the plane
offset measurement.
Input point number if necessary.
6
Press the
{F4}
(MEAS) key.
The instrument calculates and displays coordinate
and distance value of cross point between
collimation axis and of the plane. *2)
{F4}
7
Collimate the edge (P0) of the plane. *3), 4)
Collimate
P0
8
To show the slope distance (SD), press the
{
}
key.
•
Each time pressing the
{
}
key, horizontal
distance, relative elevation and slope distance are
shown in sequence.
•
To show coordinate value of point P0, press the
{
}
key.
9
Press the
{F3}
(YES) key. Next offset point
number will be displayed.
{F3}
10
To escape the measuring, press the
{ESC}
key.
The display returns to the next point number in
data collect mode.
{ESC}
*1) In case the calculation of plane was not successful by the measured three points, error displays. Start
measuring over again from the first point.
*2) Data display is the mode beforehand of offset measurement mode.
*3) Error will be displayed when collimated to the direction which does not cross with the determined plane.
*4) The reflector height of the target point P0 is set to zero automatically
PLANE
N002#:
SD: m
MEAS --- NP/P ---
PLANE
N003#:
SD: m
MEAS --- NP/P ---
PLANE
PT#
→
PT-11
PCODE :TOPCON
INPUT SRCH --- MEAS
HR: 80°30'40"
HD: 54.321 m
VD: 10.000 m
>OK? [YES][NO]
HR: 75°30'40"
HD: 54.600 m
VD: -0.487 m
>OK? [YES][NO]
V : 90°30'40"
HR: 75°30'40"
SD: 54.602 m
>OK? [YES][NO]
PLANE
PT#
→
PT-12
PCODE :TOPCON
INPUT SRCH --- MEAS
PT#
→
PT-12
PCODE :TOPCON
R.HT : 1.200 m
INPUT SRCH MEAS ALL
