TigerStop TigerSaw 1000, Руководство по установке

Страница: 34 / 68

31
1.At the menu select screen, press the [Setup] soft key to access the
Setup menu.
2.Press the button 2 times.
To measure kerf...
1. Cut a sample piece and measure it with a caliper. Record your measurement.
2. Cut this piece in half. Put the two pieces together as if they were one piece and re-measure with a
caliper.
3. The difference between the measurement on step 1 and the measurement on step 3 will be your
kerf value.
4. Enter your kerf value and press the [Done] soft key to save the parameter.
Note: It is important to re-measure the kerf every time the saw blade is changed.
Set the Head and Tail Cut
The head cut and tail cut settings apply a global trim cut to all push, pattern and pull part lists. When
using TigerSaw 1000 in crayon defecting mode, a head cut of at least .250 inches is required.
Head Cut
1.At the menu select screen, press the [PartList] soft key to access
the Part List menu.
2.You will be taken to the head cut setting.
To change Head Cut...
1. Enter the new head cut value.
2. Press the [=] button to save the value.
Tail Cut
1. Press the button one time.
2.you will be taken to the tail cut setting.
To change Tail Cut...
1. Enter the new tail cut value.
2. Press the [Done] soft key to save the parameter.
Set the Load Offset
The load offset is a global parameter that applies to all push and pattern parts lists. Load offset will
add to the load position to give the operator more room to load the stock. When using TigerSaw 1000