TigerStop TigerSaw 1000, Руководство по установке

Страница: 12 / 68

9
Installation Requirements
Power Requirements
Saw Control Power
All phases must be balanced from each phase to ground and from phase to phase. Voltages must
be /- 10%. Line to neutral voltage and line to line voltage must NOT exceed 240VAC.
WARNING! Do NOT use a high leg delta circuit to power the TigerSaw 1000 system!
If you are not sure what kind of circuit you are using, STOP! Have a qualified electrician confirm the main power circuit.
Circuit Breaker
Use the following guide lines when choosing a circuit breaker.
TigerSaw 1000 needs to have its own dedicated circuit. No other equipment or devices should be
on the same circuit.
WARNING! Do NOT use a high leg delta circuit to power the TigerSaw 1000 system!
If you are not sure what kind of circuit you are using, STOP! Have a qualified electrician confirm the main power circuit.
Grounding
TigerSaw 1000 must be properly grounded. TigerStop recommends a qualified electrician perform
the grounding of the system. In the event of electrical short, grounding provides a path of least resis-
tance to reduce the risk of electrical shock.
WARNING! Operating TigerSaw 1000 without proper grounding can result in electric
shock or electrocution.
Air Requirements
•Air must be clean and dry.
•Air must be filtered to 2.5 microns and free of oil and moisture.
•Use of industrial full size air dryer rated for 6 cfm flow is required.
•If air quality and dryness does not meet the standard, TigerSaw warranty may be voided.
Table 1: Saw Control Power
208VAC 3 Phase 27 amps
230VAC 3 Phase 24 amps
Table 2: Circuit Breaker
208VAC 3 Phase 50 amps
230VAC 3 Phase 40 amps
Table 3: Air Requirements
Minimum air pressure 80 psi
Minimum flow 6 cfm