ThermoFisher Scientific Vanquish VC-D11, Руководство по эксплуатации, Страница: 95 / 192

6 • Operation
Diode Array/Multiple-Wavelength Detectors (VC-D11, VC-D12, VF-D11)
Operating Manual Page 95
6.6 Important Operating Parameters
The commands and parameters described in the table should be
considered for simple routine operation of the device. You can usually
access these parameters from the Chromeleon user interface.
If a parameter listed below is not available in the Chromeleon software,
consider updating the firmware and Chromeleon version.
TIP The Instrument Method Wizard provides different parameter view
modes. Depending on the parameters to be set, you can select the
desired view mode (for example,
Easy or Advanced ).
For more information, refer to Chromeleon Help and documents .
General Parameters
Parameters Description
UV lamp
VIS lamp (optional)
Turn on the UV and/or VIS lamp before starting an
analysis (
UV_Lamp = On, Visible_Lamp =On ). This setting
allows turning on and off the UV and VIS lamp of the
device.
To turn on the UV lamp automatically after power on, set
AutoactivateUV_Lamp to On .
To turn on the VIS lamp automatically after power on, set
AutoactivateVIS_Lamp to On .
UV_VIS The UV_VIS signal channels ( UV_VIS_x ) that are available
for data acquisition are listed in the dialog box for the
detector in the Instrument Configuration Manager. Select
the required signal channels.
The device can record several signal channels
simultaneously, thus at several different wavelengths (for
the number of available channels, see
Detector
( } page 170) ).
Acquisition On
Acquisition Off
Start or stop the data acquisition.