ThermoFisher Scientific Vanquish VC-D11, Руководство по эксплуатации, Страница: 155 / 192

7 • Maintenance and Service
Diode Array/Multiple-Wavelength Detectors (VC-D11, VC-D12, VF-D11)
Operating Manual Page 155
Preparations
1. Unpack the replacement device. Remove the slide-in module from
its enclosure as described in Removing the Slide-In Module
( } page 152) .
2. Verify that the device enclosure into which the slide-in module shall
be installed is clean. If required, clean the inner and outer surfaces
of the enclosure. See
Cleaning or Decontaminating the Device
( } page 119) .
3. When installing the slide-in module to an enclosure in the system
stack, check that the enclosure is placed correctly in the stack.
Follow these steps
1. Push all tubing and capillaries, which are present in the tubing chase
of the Vanquish system modules, into the tubing chase. Otherwise,
you will not be able to insert the slide-in module properly into the
enclosure in the next step.
2. On the slide-in module, check that you can move the captive screws
back and forth with your fingers. If you cannot, screw them in until
you can.
3. Insert the slide-in module in the enclosure. The following steps
require a team effort:
a) Take the slide-in module on both sides from below.
b) Lift the slide-in module to the height of the enclosure.
c) Place the slide-in module in the enclosure so that the module
sits in the enclosure by approximately 25 cm.
d) Push the slide-in module onto the rails and into the enclosure
until the slide-in module sits completely in the enclosure.
Figure 37: Inserting the slide-in module