ThermoFisher Scientific Vanquish VC-D11, Руководство по эксплуатации, Страница: 108 / 192

6 • Operation
Page 108 Diode Array/Multiple-Wavelength Detectors (VC-D11, VC-D12, VF-D11)
Operating Manual
6.8 Shutting Down the Device
If the device will not be operated for some time, follow the instructions
in this section to shut down the device.
TIP The Chromeleon software provides procedures for automatically
preparing the chromatography system for shutdown. The procedures
include, for example, operations for reducing the flow rate, reducing the
temperature in temperature-controlled devices, and turning off the
detector lamps. For information about
Smart Shutdown and Smart
Standby , refer to the Chromeleon Help .
6.8.1 Short-Term Shutdown (Interruption of Operation)
To interrupt operation of the device for a short period (short-term
shutdown), for example, overnight, observe these guidelines for the
Vanquish system modules, as required by your system arrangement:
• For your Vanquish detector, note the following:
Detector Type Description
Charged aerosol
detector Check that sufficient gas is available to continue gas flowing
through the detector. This is to prevent any build-up of
residue from solvents or analytes. Gas must be flowing when
pump flow is delivered to the detector.
UV/VIS detectors The lamp(s) in the detector can remain turned on.
Variable wavelength detector and VH-D10 diode array
detector only:
The shutter can be moved to a closed position
for protection of the flow cell.
Fluorescence
detector Turn off temperature control for the flow cell.
• Apply a flow of 0.05 mL/min and have the pump deliver an
appropriate solvent.
Check the lower pressure limit for the pump and adapt the value if
necessary. If the pressure falls below the lower limit, the pump stops
the flow.
• Set the injection valve in the autosampler to the Inject position.
• Make sure that the temperature of the column does not exceed
40 °C.