ThermoFisher Scientific Vanquish VC-D11, Руководство по эксплуатации, Страница: 58 / 192

5 • Installation
Page 58 Diode Array/Multiple-Wavelength Detectors (VC-D11, VC-D12, VF-D11)
Operating Manual
No. Description
7 USB (Universal Serial Bus) port ("B" type connector)
Allows connection to other modules in the Vanquish system or the computer
on which the data management system is installed, such as the Chromeleon
software
TIP Thermo Fisher Scientific recommends using the USB ports only as
described above. If the USB ports are used for any other purpose,
Thermo Fisher Scientific cannot ensure proper functionality.
Follow these steps
NOTICE
• Never use defective communication cables. If you suspect that a
cable is defective, replace the cable.
• To ensure trouble-free operation, use only the cables provided by
Thermo Fisher Scientific for connecting the device.
1. Place the device in the system as required by the system
configuration. For details, refer to the Vanquish System Operating
Manual .
2. Connect the required interface cables to the device. For information
about how to connect the device to other modules in the Vanquish
system or to the chromatography data system computer, refer to
the
Vanquish System Operating Manual .
3. Connect the power cord (see Connecting the Power Cord
( } page 58) ).
5.5.3 Connecting the Power Cord
NOTICE
Condensation in a device can damage the electronics.
• Before connecting the devices to the power line, be sure that no
condensation is present in the devices.
• If you suspect that condensation is present, allow the device to
warm up to room temperature slowly. Wait until the condensation is
completely gone before proceeding.
1. Verify that the power switch on the device is set to OFF.
2. Connect the power cord to the power inlet connector on the device.
3. Connect the free end of the power cord to an appropriate power
source.