Thermo King SLXi Spectrum, Руководство по обслуживанию

Страница: 14 / 342

Safety Precautions 2-2
SL-400e, SLX, SLXe AND SLXi WITH SMART REEFER 2/3 (SR-2/SR-3) CONTROLLER
This unit is capable of automatic operation and could start at any time.
The microprocessor on/off switch must be placed in the Off position ("0") before:
• any inspection, maintenance or service operation is performed on the unit
• the unit is placed in a location where a start-up would be undesirable (for example, a confined area).
The microprocessor on/off switch supplies or removes electrical power to the microprocessor. It is located between the
communication ports on the left side of the Smart Reefer 2/3 control panel.
REFRIGERANT
Note: At Thermo King, we recognize the need to preserve the environment and limit the potential harm to the ozone layer that
can result from allowing refrigerant to escape into the atmosphere. Fluorinated Green House gases should not be ventilated
to atmosphere. We strictly adhere to a policy that promotes the recovery and limits the loss of refrigerant into the atmosphere.
General Information
When removing refrigerant from a unit, a recovery process that prevents or minimises refrigerant loss to the atmosphere is
required by law.
When a refrigerant is exposed to the atmosphere in the liquid state, it evaporates rapidly, freezing anything it contacts. If
refrigerant contacts the skin, severe frostbite can result.
First Aid
In the event of frost bite, the objectives of First Aid are to protect the frozen area from additional injury, to warm the affected
area rapidly, and to maintain respiration.
• EYES: For contact with liquid, immediately flush eyes with large amounts of water and get prompt medical attention.
• SKIN: Flush area with large amounts of lukewarm (not hot) water. Do not apply heat. Remove contaminated clothing and
shoes. Wrap burns with dry, sterile, bulky dressing to protect from infection/injury. Get medical attention. Wash contaminated
clothing before reuse.
• INHALATION: Move victim to fresh air and use cardiopulmonary resuscitation or mouth-to-mouth ventilation if necessary.
Stay with victim until arrival of emergency medical personnel.
•
REFRIGERANT OIL
General Information
Observe the following precautions when working with or around synthetic or polyester refrigerant oil:
• Do not allow refrigerant oil to contact your eyes.
• Do not allow prolonged or repeated contact with skin or clothing.
• To prevent irritation, you should wash thoroughly immediately after handling refrigerant oil. Rubber gloves are recommended
when handling polyol ester oil.
First Aid
• EYES: Immediately flush eyes with large amounts of water for at least 15 minutes while holding the eyelids open. Get prompt
medical attention.
• SKIN: Remove contaminated clothing. Wash thoroughly with soap and water. Get medical attention if irritation persists.
• INHALATION: Move victim to fresh air and restore breathing necessary. Stay with victim until arrival of emergency
personnel.
• INGESTION: Do not induce vomiting. Contact a local poison control center or physician immediately.