Thermo King SLXi Spectrum, Руководство по обслуживанию

Страница: 134 / 342

Electrical Maintenance 8-6
Alternator Removal
1. Disconnect the battery power from the unit.
2. Remove the wires from the alternator terminals. Note the location of each wire so they will be installed correctly.
3. Remove the mounting bolts and remove the alternator.
Alternator Disassembly
1. Remove the pulley and the fan. Remove the nut, lock washer, pulley, fan and the spacer from the rotor shaft.
2. Remove the capacitor.
a. Unplug the wire from the capacitor to the + terminal.
b.Loosen the capacitor mounting screw and remove the capacitor.
3. Remove the brush-regulator assembly.
a. Remove the field (green) wire from the terminal on the alternator.
b.Remove the brush-regulator assembly by removing the two mounting screws.
4. Remove the front housing.
a. Remove the nut, lock washer, flat washer, and isolation washer from the B+ terminal on the alternator.
b.Remove the four screws on the front of the alternator that surround the rotor shaft.
c. Remove the nut, lock washer, and flat washer from the longest of the four through bolts on the alternator.
d.Mark the rear housing, front housing, stator, and the longest through bolt to aid in assembly later.
e. Remove the four through bolts from the alternator.
f. Remove the front housing. (Front housing should slide off the front rotor shaft bearing with minimal force.)
5. Remove the rotor. Support the rear housing and stator. Slide the rotor shaft assembly toward the front of the alternator. This
can be done by hand, but considerable force is needed.
NOTE: The nut can be screwed on the rotor shaft to aid in pulling on the rotor shaft.
Mark Housing and Stator
1. Longest Through Bolt
2. Place marks here
3. Front Housing
4. Stator
5. Rear Housing