Tennant 92 GR, Руководство оператора

Страница: 61 / 79

92GR MM188 (11---87)
3-65562
4. Slide a new fusible link over the link mounting
pins.
A
B
C
D
01483
FUSIBLE LINK INSTALLATION
A. Fire Door
B. Retaining Clip
C. Fusible Link
D. Fire Door Hook
5. Push the link retaining clips onto the mounting
pins.
6. Open the fire door.
7. Place the fire door hook over the middle of the
fusible link.
8. Close the hopper inspection door.
DEBRIS HOPPER
The debris hopper collects debris swept up by the
main brush. The hopper has one regularly scheduled
adjustment --- hopper floor clearance. Check it after
every 50 hours of operation. Proper floor clearance
must be maintained to prevent the hopper from
trailing debris.
TO CHECK AND ADJUST HOPPER FLOOR
CLEARANCE
1. Place the hopper in the “operating” position,
stop the engine, and engage the parking
brake.
WARNING: Always stop the machine on a
level surface, stop the engine, and engage
the parking brake before working on the machine
to keep it from rolling.
2. Slide a 1.5 in (40 mm) thick block under each
side of the rear of the hopper. This is the
amount of floor clearance needed by the
hopper. If the hopper needs adjustment,
continue.
3. Loosen the floor clearance bolt jam nut on each
side of the hopper.
A
B
01485
FLOOR CLEARANCE ADJUSTMENT BOLT
A. Adjustment Bolt
B. Jam Nut
4. Thread the adjustment bolts in to increase the
floor clearance or thread the adjustment bolts
out to decrease floor clearance.
5. Tighten the jam nuts.
STABILIZER LEG
The machine stabilizer leg is a safety device which,
when the machine is being high dumped, projects
downward to act as an anti---tipping device. Check
the stabilizer leg daily to be sure it is down when the
machine is being high dumped and is fully retracted
when the hopper is in the “operating” position.
Check for proper operation daily. Lubricate the leg
pivot pin after every 200 hours of operation.