Tennant 92 GR, Руководство оператора

Страница: 60 / 79

3-65561
92GR MM188 (11---87)
9. Lift the dust filter shaker assembly off each of
the dust filter elements.
A
B
01481
REMOVING DUST FILTER SHAKER ASSEMBLY
A. Dust Filter Shaker Assembly
B. Dust Filter Element
10. Lift the shaker shims off the filters and filter
frames.
11. Lift the dust filter elements out of the dust filter
frames.
12. Clean or discard the dust filters as required.
TO INSTALL HOPPER DUST FILTERS
1. Place the cleaned or new dust filters in the
hopper dust filter frames with the arrows
pointing up.
A
B
01482
INSTALLING DUST FILTER
A. Dust Filter
B. Dust Filter Frame
2. Place the four shaker shims in position.
3. Slide the dust filter shaking assemblies in
position over the dust filters.
4. Thread the two allen head socket bolts through
the mounting springs and into the dust filter
frames of each filter. Tighten the bolts.
5. Replace the two side L brackets and four filter
retaining tabs.
6. Reconnect the shaker motor wire connectors.
7. Push the hopper cover open, lower and store
the prop arm under its retaining clip, and close
the hopper cover.
HOPPER FUSIBLE LINK
The hopper fusible link is a device which, in case of
a fire in the hopper, allows the hopper fire door to
close, cutting off air to the fire.
The fusible link is positioned between the hopper fire
door and the hopper frame. It is accessible through
the hopper inspection door.
If a loss of dust control is noticed, check the fusible
link for breakage or failure due to heat.
TO REPLACE HOPPER FUSIBLE LINK
1. Stop the engine and engage the machine
parking brake.
WARNING: Always stop the machine on a
level surface, stop the engine and engage
the parking brake before working on the machine
to keep it from rolling.
2. Open the hopper inspection door.
3. Remove the existing pieces of fusible link and
their retaining clips.