Tennant 92 GR, Руководство оператора

Страница: 70 / 79

3-65571
92GR MM188 (11---87)
3. Raise the hopper, engage the hopper support
bar, and lower the hopper onto the hopper
support bar.
WARNING: Always engage the hopper
support bar before working under a raised
hopper. Do not rely on the machine hydraulic
system to keep the hopper in the “raised”
position. The hydraulic system may leak
internally, allowing the hopper to lower, crushing
anything under it.
4. Stop the engine.
WARNING: Always stop the machine on a
level surface, stop the engine, and engage
the parking brake before working on the machine
to keep it from rolling.
5. Remove the hopper side seal retaining strip
mounting bolts.
A
B
01488
HOPPER SIDE SEALS
A. Hopper Side Seal
B. Seal Retaining Strip
6. Remove the hopper side seal retaining strip
and hopper side seal.
7. Thread the retaining strip mounting bolts
through the retaining strip, the hopper side
seal, and into the machine frame.
8. Tighten the mounting bolts.
9. Start the engine.
10. Raise the hopper, lower the hopper support
bar, and lower the hopper.
11. Stop the engine.
BRUSH DOOR SKIRTS
The brush door skirts are located on the bottom of
each of the two brush compartment doors. These
skirts seal the brush compartment. The seals should
be inspected for wear or damage daily.
TO REPLACE AND ADJUST BRUSH DOOR SKIRTS
1. Stop the machine on a smooth, level surface.
2. Stop the engine and engage the machine
parking brake.
WARNING: Always stop the machine on a
level surface, stop the engine, and engage
the parking brake before working on the machine
to keep it from rolling.
3. Open the brush door.
4. Remove the brush door skirt retaining bolts.
A
B
C
01489
BRUSH DOOR SKIRT
A. Brush Door
B. Brush Door Skirt
C. Skirt Retaining Strip
5. Remove the skirt retaining strip and the door
skirt.
6. Position the new door skirt and skirt retaining
strip on the brush door.
7. Thread the skirt retaining bolts through the
brush door, the door skirt, and into the skirt
retaining strip.
NOTE: The brush door skirts have slotted holes to
allow for a ground clearance adjustment. The door
must be closed for proper adjustment.