Tennant 92 GR, Руководство оператора

Страница: 26 / 79

2-11
92GR MM188 (10---87)
MACHINE OPERATION
NORMAL SWEEPING OPERATION
A normal sweeping operation consists of seven
typical operations: pre---start checklist, starting
machine, sweeping, dumping hopper, post operation
checklist --- --- engine operating, stopping machine,
and post operation checklist --- --- engine stopped.
The Pre---Start Checklist lists things to check before
starting the machine.
To Start Machine lists the steps required to start the
machine.
To Sweep lists things to keep in mind before and
during the sweeping operation.
To Dump Hopper lists the steps required to dump
the hopper.
Post Operation Checklist --- --- Engine Operating lists
things to check before stopping the machine engine.
To Stop Machine lists the steps required to stop the
machine.
Post Operation Checklist --- --- Engine Stopped lists
things to check after stopping the machine engine.
PRE---START CHECKLIST
Check under machine for leak spots.
Check engine lubricating oil level.
Check fuel level.
Check brakes and controls for proper operation.
Check service records to determine service require-
ments.
TO START MACHINE
NOTE: Before starting machine, perform the
pre---start checks.
1. The machine operator must be in the
operator’s seat with the directional control
pedal in the “neutral” position and with a foot
on the brake pedal or with the parking brake
engaged.
WARNING: Before operating the machine,
make sure all safety devices are in place
and operate properly. Check the foot and parking
brakes and the steering control for proper
operation. Do not start the machine unless you
are in the operator’s seat with a foot on the brake
pedal or have the parking brake engaged and the
directional control pedal in the “neutral” position.
Failure to do so could result in severe personal
injury.
2. Move the throttle control lever to the “full”
position.
3. Turn the ignition key clockwise to the “on”
position. The diesel pre---heat indicating lamp
may light. Wait until the lamp goes off and then
turn the key fully clockwise to the “start”
position to start the engine. Release the key as
soon as the engine starts and the key will place
itself in the “on” position.
NOTE: The diesel pre---heater stops when the
ignition key is advanced past the “on” position. To
reactivate the diesel pre---heater, the key must be
turned back to the “off” position to reset the pre---heat
solenoid.
NOTE: Do not operate the starter motor for more than
10 seconds at a time or after the engine has started.
Allow the starter to cool between starting attempts.
The starter motor may be damaged if it is operated
incorrectly.
4. Allow the engine and hydraulic system to warm
up three to five minutes.
5. Disengage the machine parking brake.
6. Drive the machine to the area to be swept.
TO SWEEP
Plan the sweeping in advance. Try to arrange long
runs with minimum stopping and starting. Sweep
debris from very narrow aisles into main aisles ahead
of time. Do an entire floor or section at one time.