Teledyne 6 RU Chassis, Руководство по эксплуатации

Страница: 17 / 172

6 RU SSPA Chassis Operations Manual 202058 REV AA 17
2.1.2 Rear Panel Features
Figure 2-2
shows a typical outline drawing of the rear panel view.
2.1.2.1 RF Input Port (J1) [Type N(F)]
The type N female connector on the right side of the rear panel is used for RF input.
Note
: Maximum RF Input Power of +15 dBm.
2.1.2.2 RF Output Port (J2)
The waveguide in the middle of the rear panel is the conduit for the RF Output. C-Band
amplifiers use WR137 waveguide with CPRG137 flange, while Ku-Band amplifiers use
WR75 waveguide with grooved (PBR-120) flange. X-Band units employ WR112 rigid
waveguide with CPRG112 flange.
Warning! Do not operate the amplifier without having a termination
or mating connection at the RF Output. RF Hazard warnings apply.
2.1.2.3 Switch Port (J3) [Molex 43810-0002]
A 6-pin Molex connector header with blind insertion system guides (mates with Molex
P/N 39-01-2060) is used in a 1:1 Redundancy System to provide switching for the
waveguide transfer switch (RF Switch).
Table 2-1
shows the pin-outs for the Switch
Port (J3).
Figure 2-2: 6 RU SSPA Chassis Rear Panel