Deleting the SFI timer event
>
If you would like to delete a timer event programmed
by means of the SFI, proceed as described above for
marking the appropriate programme.
>
Press the
red
function key
Timer
to open a selection
window.
>
Use the
arrow keys up/down
to mark the line
Delete timer.
>
Confirm by pressing
OK
.
Timer settings (pre- and post-run time)
In the case of SFI timer programming, the receiver obtains
the data related to the selected programme automatically
from the SFI data. Both the starting and the ending time of
the programme will be taken over correct to the nearest
minute. However, it frequently happens that the selected pro-
gramme starts a little earlier or a little later than scheduled. In
this case the start or the end of the programme may be mis-
sing from the recording. To overcome this problem, you can
enter a pre- or post-run time for the timer, in steps of one
minute at a time. The timer will now start the entered starting
time a few minutes earlier, and stop the recording a few
minutes later, than the scheduled SFI times, depending on
what you have entered.
>
Press the
red
function key
Timer
to open a selection
window.
>
Use the arrow keys up/down to mark the line
Timer
settings
.
>
Confirm by pressing
OK
. A menu will be displayed,
allowing you to enter the pre-and post-run times. (Fig.
7-20)
>
Now use the
arrow keys up/down
to mark the line
Timer pre-run time
resp.
Timer post-run time
.
>
Use the
numeric keys
to enter the desired pre- or
post-run time in minutes.
>
Press the
green
function key
Accept
, to store the
setting, and to return to the previous SFI table.
7.15.7.3 SFI programme overview
You can use the SFI programme overview to display a table
with the whole day’s programme of a single channel. To do
this, proceed as follows:
>
Press the
SFI
key. If you have selected the start cate-
gory
Overview,
see Point 9.2.3, the SFI table
„
Now
“ will be displayed.
>
Press the
blue
function key
SFI Menu
.
41
(Fig. 7-20)
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:37 Uhr Seite 41
