6.4.1 Switching DiSEqC on and off
DiSEqC (
Di
gital
S
atelliten
Eq
uipment
C
ontrol) is a digital
switching/controlling signal used to control DiSEqC-compati-
ble components via the antenna cable. If your external unit is
equipped with DiSEqC components, you must switch the
DiSEqC controlling function on:
>
In this line, use the
arrow keys left/right
to switch
DiSEqC on
or
off
.
As only one LNB can be controlled when the DiSEqC
function is switched off, the menu is limited to the con-
figuration of a single LNB.
6.4.2 Antenna signals
Your receiver is equipped with two tuners. This allows you to
record one programme while viewing another programme. So
that you can enjoy the full benefit of the functions of your twin
receiver for both recording and playback, you should definite-
ly use two separate antenna connections (antenna signals).
Please also note Point 8.1.
>
In this line, use the
arrow keys left/right
to set
the number of antenna signals to
2
, if you are connec-
ting your receiver to two separate antenna connec-
tions.
If only one antenna connection is available, then set
this item to
1
. This means that while you are recording
a programme, you will only be able to view other pro-
grammes being broadcast on the same receiving band
as the programme being recorded.
6.4.3 Setting the switching matrix
The menu lists the four switching criteria for the DiSEqC con-
trol. You receiver is pre-programmed so that ASTRA is recei-
ved on switch setting A/A and Eutelsat is received on setting
B/A of a multi-switch. If the switching matrix of your receiving
installation is set up differently, or if you are receiving diffe-
rent satellites, you can adjust the settings of your digital
receiver to those of the receiving installation as follows.
>
Use the
arrow keys
to select a DiSEqC switch posi-
tion (1-4) to which you wish to allocate a satellite (e.g.
A/B 3 No satellite
), and mark this line.
23
BED_ANL_DIGICORDER_S2_28/03.QXD 30.03.2006 11:37 Uhr Seite 23
