TallyGenicom LGe06, Руководство оператора

Страница: 67 / 108

Chapter 3: Printer Menus and the Control Panel
3–67
Table 3 - 2. Bar Code Dot Density
DarkBar Selection "Normal" Mode "Dark" Mode
Low (Default) 60 x 72 60 (120) x 144
Medium 60(120) x 144 120 x 144
High 120 x 144 120 x 144
Modplot
This parameter eliminates the need to send an Align to Line Boundary Command
(Tally ANSI) or an extra Line Feed ( LF ) Control Code (Printronix) when exiting
Plot Mode. Whenever you are using Plot Mode in these emulations, set this
parameter to ON to avoid graphic and text alignment problems . (Modplot ON is
the Default selection.) In addition to Code V and PGL graphics, this parameter
also applies to Tally ANSI and Printronix style graphics. It does not apply to text
following Epson or Proprinter graphics.
Figure 3 - 3. Modplot Example
Version
This parameter controls the version of Code V the printer emulates. Version 2 is
the default.
Descender
This parameter controls insertion of the character descender gap between print
lines.
Fixed: The descender gap is always inserted after the line whenever Descender
Mode is ON regardless of whether descenders are present or not. (Default)
Auto: The descender gap is only inserted after lines containing characters with
descenders.
Line 1: Character Data
Line 3: Character Data
Line 2: Plot Data
On
Off
Line 1: Character Data
Line 3: Character Data
Line 2: Plot Data
Config Menu
⇒
Graphics