TallyGenicom LGe06, Руководство оператора

Страница: 57 / 108

Chapter 3: Printer Menus and the Control Panel
3–57
Reset
This parameter resets the gap setting. If Detect Mode is Auto, the next time the
TOF key is pressed or a print run is started, a print gap detection operation will
be performed. If Detect Mode is Manual, the Print Gap will be set to 190 (the
maximum gap setting).
Mode
This parameter determines whether a print gap detection operation is performed
automatically. Auto is the default and if set, a gap detection process will be
performed when:
(1) the printer has been off but is now turned on, and a TOF is set;
(2) the printer has been off but is now turned on, and a print run is started;
(3) a Paper Out Fault has been cleared, and either the TOF is set or a print
run is started;
(4) the printer has been off but is now turned on, and a print gap adjustment is
made using the Print Gap “+” or “-” keys.
If Manual is selected, a gap detection process will not be performed under the
four conditions listed above. Instead, whenever the print gap set point must be
applied, the print gap value stored in the current configuration will be used. The
allowable adjustment range is 0 to 190. If the current configuration has an
uninitialized gap value, the platen will move to the default value of 190.
Profile is the mode that must be set when using the Gap Zone feature.
Creating a Gap Zone Profile
A Gap Zone Profile is created automatically in four steps:
Step 1 – Load the Form
Load the form for which the profile will be generated; doublecheck the Top
of Form position with Form Length .
Step 2 – Set Profile Mode
Set the Mode Parameter to Profile .
Step 3 – Create the Profile
Select the Detect parameter. Note that this operation will take approximately
five to six minutes for an 11 inch form. Also note that the print gap detection
operation will leave small dots imprinted on the form, so the sample form
will have to be discarded.
If the printer is placed Online while in Print Gap Profile Mode, and a profile
does not exist (i.e. the Detect function was not performed), then a Profile
Error message will be displayed on the control panel.
Step 4 – Save the Profile
Once the Gap Zone Profile is created, you will probably want to save it for
future use. By saving the Current Configuration into any of the ten saved
printer configurations, the Gap Zone Profile is automatically saved along with
the other configuration parameters. If it isn’t saved, it will be lost when the
printer is powered off.
Also see page 2-30 on Creating a Gap Zone Profile, and page 2-31 for Using a
Saved Gap Zone Profile.
Operator Menu
⇒
Print Gap