SYRUNS SY5000 series, Руководство пользователя

Страница: 90 / 115

User Manual of SY5000 series AC Drive Commissioning
~88~

Switch on power when above settings are correct.

, output terminal of DC bus voltage of inverter
，
the third ground terminal
If the inverter damages due to above wiring error, it is not in the range of quality
guarantee.
6.2.2 Energization status confirmation
After the power is on, LED displays as 0 if works normally, as shown in Figure
6-2.RUN indicator and ERR indicator both extinguish.
Figure 6-2 LED normal display
When the input voltage is very low, after power on, LED displays P.oFF and
blinks, as shown in Figure 6-3. Meanwhile ERR indicator lights and blinks.
Figure 6-3 LED under-voltage display
After power-on, please refer to fault instructions in chapter 7 if there is other
abnormal display.
6.2.3 No-load operation
When the motor is in no-load state, use keypad to set the parameters, and
commission the motor.

Set basic frequency
Default basic frequency of inverter is 50.00Hz. Before commissioning, please
make sure that parameter value of function code b-008 (basic frequency) equals
rate frequency of motor which is 50.00HZ.

Start inverter
①
Modifty the parameter value of b-000 form 0.00 to 50.00
②
Press RUN key of control panel and release, the motor start rotating until it
reaches the setting frequency.
③
Observe the rotation direction of motor is whether correct or not, if wrong,
exchange any two connect cables of output terminal U,V,W of inverter.
④
Change b-035 from 0 to 1. And the motor reverse totates until reaches the