Subaru Legacy Outback 2006, Руководство пользователя

Страница: 238 / 456

Audio
5-71
– CONTINUED –
T
FM/AM selection button
Push the “FM” or “AM” button when the ra-
dio is on to select FM1, FM2 or AM recep-
tion.
T
Manual tuning (TUNE)
FF: For tuning to a higher frequency
FB: For tuning to a lower frequency
Turn the “TRACK/TUNE” knob clockwise
and release it immediately to increase the
tuning frequency and turn the “TRACK/
TUNE” knob counterclockwise and re-
lease it immediately to decrease the tun-
ing frequency.
Each time the knob is turned, the frequen-
cy changes 9 kHz in the AM waveband
and 0.1 MHz in the FM waveband.
V
Seek tuning (SEEK)
Turn the “TRACK/TUNE” knob and
hold it for more than a half second.
The radio will seek the next available sta-
tion and stop on it. Repeat this operation
until you find the desired station.
T
Automatic tuning (SCAN)
Press the “SCAN” button to change the ra-
dio to the scan mode. In this mode, the ra-
dio scans through the radio band until a
station is found. The radio will stop at each
station for five seconds while displaying
the frequency, after which scanning will
continue until the entire band has been
scanned from the low end to the high end.
Press the “SCAN” button again to cancel
the SCAN mode and to stop on any dis-
played frequency.
When the “SCAN” button is pressed for
automatic tuning, stations are scanned in
the direction of low frequencies to high fre-
quencies only. Automatic tuning may not
function properly if the station reception is
weakened by distance from the station or
proximity to tall buildings and hills.
AM
RPT
TRACK
FB
TUNE
FF
RDM
FM
1
500080
AM
RPT
TRACK
FB
TUNE
FF
RDM
FM
1
500081
PUSH
ON/OF
VOLUME
DISC SCAN
6
500082