Subaru Legacy Outback 2006, Руководство пользователя

Страница: 39 / 456

1-14
Seat, seatbelt and SRS airbags
by a one-second pause. If either of the un-
fastened seatbelts is fastened at this time,
the warning light corresponding to that
seatbelt will immediately go off but the
buzzer will continue operating unless the
remaining seatbelt is fastened. This condi-
tion (continued operation of the buzzer un-
less the remaining seatbelt is fastened)
will continue for approximately 108 sec-
onds.
NOTE
If the driver’s and passenger’s seat-
belts are not fastened simultaneously
(if one seatbelt is fastened significantly
earlier or later than the other), the buzz-
er may sound longer (10 seconds max-
imum).
If the driver’s seatbelt and/or the passen-
ger’s seatbelt is still not fastened when the
108-second period has elapsed, the warn-
ing light(s) will stop flashing and the buzz-
er will stop sounding. The warning light(s),
however, will stay on continuously unless
the corresponding seatbelt(s) is fastened.
T
Latin America models
Your vehicle is equipped with a seatbelt
warning device at the driver’s seat, as re-
quired by current safety standards.
This device causes the seatbelt warning
light on the instrument panel to light up
when the ignition switch is turned to “ON”
to remind the driver to wear the seatbelt.
If the vehicle is driven at a speed no higher
than approximately 24 km/h (15 mph) with
the driver’s seatbelt not fastened, the
warning light will come on and stays on
continuously.
If the vehicle subsequently reaches a
speed of approximately 24 km/h (15 mph)
with the driver’s seatbelt not fastened, the
warning light will start a repeated cycle
consisting of five seconds of flashing fol-
lowed by a one-second pause. If the seat-
belt is fastened at this time, the warning
light will immediately go off. This condition
will continue for approximately 108 sec-
onds.
If the driver’s seatbelt is still not fastened
when the 108-second period has elapsed,
the warning light will stop flashing. The
warning light, however, will stay on contin-
uously unless the seatbelt is fastened.
T
Saudi Arabia models
Your vehicle is equipped with a seatbelt
warning device at the driver’s seat, as re-
quired by current safety standards.
This device causes the seatbelt warning
light on the instrument panel to light up for
approximately six seconds when the igni-
tion switch is turned to “ON” to remind the
driver to wear the seatbelt. If the driver’s
seatbelt is not fastened, a warning chime
sounds at the same time.
„
Rear seatbelt indicator light
(Australia models)
1) Rear seat (left position)
2) Rear seat (center position)
3) Rear seat (right position)
This indicator light is located between the
map lights. It illuminates to show only the
seating positions whose seatbelts have
been fastened.
1 2 3
100680