Subaru Legacy Outback 2006, Руководство пользователя

Страница: 115 / 456

3-8
Instruments and controls
NOTE (3.0-liter models only)
To protect the engine while the “P” or
“N” position is selected, the engine is
controlled such that the engine speed
does not become too high even if the
accelerator pedal is pressed hard.
„
Fuel gauge
The fuel gauge shows the approximate
amount of fuel remaining in the tank.
When the ignition switch is in the “LOCK”
or “ACC” position, the fuel gauge shows
“E” even if the fuel tank contains fuel.
The gauge may move slightly during brak-
ing, turning or acceleration due to fuel lev-
el movement in the tank.
If you press the trip knob while the ignition
switch is in the “LOCK” position, the fuel
gauge’s dial, needle, and rim will light up
and the needle will indicate the amount of
fuel remaining in the tank.
If, while the fuel gauge needle is indicating
the amount of fuel remaining in the tank,
you (a) do not press the trip knob for 10
seconds or (b) open and close the driver’s
door or (c) turn the ignition switch to the
“ON” position, the fuel gauge needle will
drop to the “E” position and the dial, nee-
dle, and rim will go dark.
The rim of the fuel gauge flashes five
times when the amount of remaining fuel
reaches 10 liters (2.6 US gal, 2.2 Imp gal).
If you turn the ignition switch to the
“LOCK” position and back to the “ON” po-
sition, the rim will again flash five times.
Do not operate the engine with the
pointer of the tachometer in the red
zone. In this range, fuel injection will
be cut by the engine control module
to protect the engine from overrev-
ving. The engine will resume run-
ning normally after the engine
speed is reduced below the red
zone.
300187
300195