Subaru Legacy Outback 2006, Руководство пользователя

Страница: 131 / 456

3-24
Instruments and controls
Clock (if equipped)
NOTE
If your vehicle is equipped with a navi-
gation system, refer to the separate
“Operating Instructions for Monitor
System”.
The clock shows the time while the igni-
tion switch is in the “ACC” or “ON” posi-
tion.
To adjust the time shown by the clock,
press the “+” button or the “–” button. The
indicated time will change in one-minute
increments. If you keep the button
pressed, the rate at which the indicated
time changes will speed up.
To reset the minutes to “00” with a radio
time signal, push the “SET” button. The clock will also show the time if you
press the “DISP” button while the ignition
switch is in the “LOCK” position. It is pos-
sible to adjust the time setting while the
time is being shown. If you do not press
the “+” button, “–” button, or “SET” button
for 10 seconds while the time is being
shown, the time indication will go off.
Also, the time indication will go off if you
open and close the driver’s door while the
time is being shown.
400257
300599
To ensure safety, do not attempt to
set the time during driving, as an ac-
cident from inadequate steering op-
eration could result.
300600