Subaru Legacy Outback 2006, Руководство пользователя

Страница: 49 / 456

1-24
Seat, seatbelt and SRS airbags
mately 6 seconds when the ignition switch
is turned to the “ON” position.
The following components are monitored
by the indicator:
y
Front sub sensor (Right-hand side)
y
Front sub sensor (Left-hand side)
y
Airbag control module (including impact
sensors)
y
Seatbelt pretensioner (Driver’s side)
y
Seatbelt pretensioner (Passenger’s
side)
y
Lap belt pretensioner (Driver’s side –
Australia models only)
y
Side airbag sensor (Center pillar right-
hand side – if equipped)
y
Side airbag sensor (Center pillar left-
hand side – if equipped)
y
Curtain airbag sensor (Rear wheel
house right-hand side – if equipped)
y
Curtain airbag sensor (Rear wheel
house left-hand side – if equipped)
y
All related wiring
y
And all other airbag components
„
System servicing
If the warning light exhibits any of
the following conditions, there may
be a malfunction in the seatbelt pre-
tensioners and/or SRS airbag sys-
tem. We recommend that you take
your vehicle to your nearest
SUBARU dealer immediately to have
the system checked. Unless
checked and properly repaired, the
seatbelt pretensioners and/or SRS
airbags will operate improperly (e.g.
SRS airbags may inflate in a very mi-
nor collision or not inflate in a se-
vere collision), which may increase
the risk of injury.
y
Flashing or flickering of the warn-
ing light
y
No illumination of the warning
light when the ignition switch is
first turned to the “ON” position
y
Continuous illumination of the
warning light
y
Illumination of the warning light
while driving
y
When discarding a seatbelt retrac-
tor assembly or scrapping the en-
tire vehicle damaged by a colli-
sion, we recommend that you
consult your SUBARU dealer.
y
Tampering with or disconnecting
the system’s wiring could result in
accidental activation of the seat-
belt pretensioner and/or SRS air-
bag or could make the system in-
operative, which may result in se-
rious injury. The wiring harnesses
of the seatbelt pretensioner and
SRS airbag systems are covered
with yellow insulation and the
connectors of the system are yel-
low for easy identification. Do not
use electrical test equipment on
any circuit related to the seatbelt
pretensioner and SRS airbag sys-
tems. For required servicing of
the seatbelt pretensioner, we rec-
ommend that you see your near-
est SUBARU dealer.