Subaru Legacy Outback 2006, Руководство пользователя

Страница: 125 / 456

3-18
Instruments and controls
after the engine has started.
If this light comes on when the engine is
running, it may indicate that the automatic
transmission fluid temperature is too hot.
If the light comes on while driving, it is un-
necessary to stop the vehicle, but avoid
driving up steep grades or in stop and go
traffic.
„
ABS warning light
The ABS warning light comes on when the
ignition switch is turned to the “ON” posi-
tion and goes out after approximately two
seconds.
This is an indication that the ABS system
is working properly.
The ABS warning light comes on together
with the brake system warning light if the
EBD system becomes faulty. For further
details of the EBD system fault warning,
refer to “Brake system warning light” sec-
tion in this chapter.
NOTE
If the warning light behavior is as
shown in the following, the ABS sys-
tem may be considered normal.
y
The warning light comes on right af-
ter the engine is started but goes out
immediately, remaining off.
y
The warning light remains on after
the engine has been started, but it goes
out when the vehicle speed reaches
approximately 12 km/h (8 mph).
y
The warning light comes on during
driving, but it goes out immediately
and remains off.
When driving with an insufficient battery
voltage such as when the engine is jump
started, the ABS warning light may come
on. This is due to the low battery voltage
and does not indicate a malfunction.
When the battery becomes fully charged,
the light will go out.
„
Vehicle Dynamics Con-
trol warning light (if
equipped)/Vehicle Dy-
namics Control OFF indicator
light (if equipped)
This warning light has the function of indi-
cating faults in the Vehicle Dynamics Con-
trol system and the function of indicating
that the Vehicle Dynamics Control system
has been deactivated.
It comes on in the event of a fault in the
system and is on when the system is not
operating.
This warning light comes on when the ig-
nition switch is turned to the “ON” position
and goes out after the engine has started.
It indicates that the Vehicle Dynamics
Control system is in normal operation.
If the warning light behaves as fol-
lows, the ABS system may not work
properly.
When the warning light is on (and
brake system warning light is off),
the ABS function shuts down; how-
ever, the conventional brake system
continues to operate normally.
y
The warning light does not come
on when the ignition switch is
turned to the “ON” position.
y
The warning light comes on when
the ignition switch is turned to the
“ON” position, but it does not go
out even when the vehicle speed
exceeds approximately 12 km/h (8
mph).
y
The warning light comes on dur-
ing driving.
If any of these conditions occur, we
recommend that you have the ABS
system repaired at the first available
opportunity by your SUBARU deal-
er.