FCC ID: K6630283X3S
IC ID: 511B-30283X3S
GX5000S / GX5500S Operating Manual
SELECTIVE CALLING” and section “12 RADIO SETUP MODE” for details). The LAMP,
CONTRAST, and KEY BEEP menu item accessed from the RAM+ only controls the
RAM+’s display and speaker.
DSC/RADIO Setup mode from the RAM+:
1. Press and hold down the [CALL] key until “RADIO SETUP” menu appears.
2. Press the [p]/[q] key to select “RADIO SETUP” or “DSC SETUP” menu.
3. Press the [CALL] key, then select the menu item you wish to work on by pressing the
[p]/[q] key.
4. Press the [CALL] key.
5. Press the [p]/[q] key to change the value or condition for the menu item, then press
the [CALL] key to save the new setting.
6. Press the [p]/[q] key to select “EXIT,” then press the [CALL] key to return to the
normal operation.
RADIO
SETUP-menu
DSC
SETUP-menu
NOTE
When setup menu is selected, the GX5000S/GX5500S will be temporarily disabled until the
RAM+ mic, exits from the setup mode.
13.5.1 Changing GPS Information to Vessel Position or COG
Allows customizing of the NAV data showing GPS Information. Factory default is “Your
Vessel’s Current Position,” however, following the steps below the GPS Information can be
changed to “Course Over Ground (COG).”
1. Press and hold down the [CALL] key until “RADIO SETUP” menu appears.
2. Press the [CALL] key, then select “NAV DISPLAY” with the [p]/[q] key.
3. Press the [CALL] key.
4. Press the [q] or [p] key to select “Pos (Your Vessel’s Current Position)” or “Cru
(Course Over Ground).”
5. Press the [CALL] key to store the data entered, then press the [16/9] key to exit this
menu and return to radio operation mode.
14 VH-310 HANDSET OPERATION
When the VH-310 HANDSET is connected to the GX5000S/GX5500S, most VHF, DSC,
and setup menus can be remotely operated. The VH-310 HANDSET is supplied with 7 m of
routing cable and can be extended up to 21 m using three 7 m extension cables model
CT-100. The intercom operation can be used between the VH-310 HANDSET or the
Vertex Standard Co., Ltd.
58
