Standard Horizon Quantum GX5000S, Руководство по эксплуатации

Страница: 37 / 69

FCC ID: K6630283X3S
IC ID: 511B-30283X3S
GX5000S / GX5500S Operating Manual
2. Turn the CHANNEL selector knob to select “Individual.” (To cancel, select “Exit” with
the CHANNEL selector knob or press the [16/9] key.)
3. Press the [ENT] key. The transceiver will beep, and the “Individual directory” will
appear.
4. Turn the CHANNEL selector knob to select the “Individual” you want to contact.
5. Press the [ENT] key, then turn the CHANNEL selector knob to select the operating
channel you want to communicate on and press the [ENT] key.
6. Press the [ENT] key again to transmit the individual DSC signal.
7. After INDIVIDUAL CALL is transmitted, the transceiver will wait 8 seconds for the
acknowledgment. If the reply signal is not received, the transceiver will transmit
again.
8. After the second INDIVIDUAL CALL is transmitted, if the reply signal is not received,
the display will be as shown in the illustration on the right. To send the call again,
press the [ENT] key.
9. When an individual call acknowledgment is received, the established channel is
automatically changed to the channel which is selected on step 5 above and a
ringing tone sounds.
10. Press any key to listen to the channel to make sure it is not busy, then key the
microphone and call the other vessel you desire to communicate with.
Manual Calling
You may enter an MMSI number manually to contact without storing it in the Individual
Directory.
1. Press the [CALL (MENU)] key. The “DSC Operation” menu will appear.
2. Turn the CHANNEL selector knob to select “Individual.” (To cancel, select “Exit” with
the CHANNEL selector knob or press the [16/9] key.)
3. Press the [ENT] key. The transceiver will beep, and the “Individual directory” will
appear.
4. Turn the CHANNEL selector knob to select “Manual,” then press the [ENT] key.
5. Turn the CHANNEL selector knob to scroll through numbers, 0-9. To enter the
desired number and move one space to the right, press the [ENT] key. Repeat this
procedure until all nine spaces of the MMSI number which you want to contact are
entered.
6. If a mistake was made entering in the MMSI number repeat pressing the [H/L(NAV)]
key until the wrong number is selected, then move the channel knob to correct the
entry.
Vertex Standard Co., Ltd. 37