South Bend Tools SB1119, Руководство пользователя, Страница: 57 / 76

South Bend Tools
For Machines Mfd. Since 3/21 Model SB1119/SB1120
-55-
S E R V I C E
— If there are no gaps anywhere between
straightedge and fence faces, no truing is
necessary.
— If there is a gap between straightedge and
fence faces, proceed to Step 6.
6. Remove both fences and resurface as one
unit. You can perform this operation on a
jointer as shown in Figure 93.
Figure Figure 93. Example of resurfacing fences on a jointer. . Example of resurfacing fences on a jointer.
Make sure screws are countersunk deep
enough so cutter will not come in contact
with heads of screws! Check screw depth
after each pass to ensure that screws will not
contact cutter!
Aligning Pulleys
Pulley alignment is important to the performance
of your shaper. If the pulleys are just slightly out
of alignment, the shaper may suffer from power
loss and decreased V-belt life. When the pulleys
are parallel and aligned with each other, they are
said to be coplanar—in the same plane.
To align pulleys:
1. DISCONNECT MACHINE FROM POWER!
2. Open cabinet door.
3. Hold straightedge up to pulleys to determine
if they are both aligned and parallel, as
shown in Figure 94.
— If pulleys are aligned and parallel, no
adjustment is necessary.
— If pulleys are not aligned and parallel,
proceed to Step 4.
Figure Figure 94. Example of checking pulley alignment with . Example of checking pulley alignment with
straightedge. straightedge.
Tools Needed Qty
Precision Straightedge ..........................................1
Precision Level ......................................................1
Wrench or Socket 16mm .......................................1
!