40
Important note: all alarms cause the machine to shut down. The alarm must be
reset and restarted. To reset the unit, press the “On/Off” button for 10 seconds until
the alarm sounds.
- Failures
Failures
Maintenance “service”
Air mass sensor fault
Low pellet level
Door open
Air temperature sensor faulty
Failure of the water temperature sensor
Water pressure sensor faulty
Water pressure near the extremes of the operating range
Table 5 - List of failures
Important notice: A “
service
” warning on the display (maintenance due)
indicates that the unit has exceeded 2100 operating hours. In this case, the client must
perform the unit's maintenance procedure (following the instruction on the Technical
Manual). Once this procedure is completed the hour meter may be reset, to clear the
waning message. This message does not impact the normal operation of the unit. It is
simply a warning.
Important notice: The errors can be reset only when the error information is
flashing on the display. To reset the error, press the “Mode” button once while
displaying the error.
WARNING!
In case of an emergency, turn off the unit by following the normal shutdown procedure.
WARNING!
THE UNIT BECOMES HOT DURING OPERATION SO CARE MUST BE TAKEN
ESPECIALLY WHEN HANDLING THE DOOR GLASS AND DOOR HANDLE.
Содержание Hidro 12
